Komatsu BAR 238-46-81120 DRAWBAR	Size Unit:Inch; Material:52100 Steel; Diameter(inch):17/64; Days to Ship:8 Days;
Komatsu BAR 10G-50-23112 CROSS BAR	Shape:Flange Type; Holder Surface Treatment:Black Oxide Coating; Flange O.D. H(φ):77; Bearing I.D. d(mm):25; Days to Ship:8 Days; Bearing Used:Deep Groove Ball Bea; Seals:DD (Contact Rubber S; Type:Bearings with Housin; Bearing Retained:Yes (with retaining;
Komatsu BAR 22B-958-8670 BAR	Pillow/Plummer Block Style:Split Cylindrical Ho; Cr - Dynamic Load Rating:208398 lbf; Weight:557 lb; Ca - Axial Load Rating:16006 lbf; Maximum Speed:1120 rpm; Bearing Type:Split Cylindrical Re; Bearing - Housing - Seal:MSM175BRH; Dimension H1:1.7 in; Dimension H2:21.5 in; Dimension H:10.748 in;
Komatsu BAR 56D-54-31250 BAR	Recommended tightening torque for set screw:16.8 Nm; L2:16 mm; N:29mm; H:117 mm; C:35.1 kN; A5:32.6 mm; H2:83 mm; Designation of housing:T210-; B:51.6 mm; Designation of bearing:UC210-31G2T04;
Komatsu BAR 11K-50-41110 BAR	Cg - Geometry Factor7:0.148; Design Units:Imperial; r - Cup Frontface To Clear Radius2:0.06 in; Y1 - ISO Factor5:2.31; e - ISO Factor4:0.29; D:18.5000 in; K - Factor3:2; Y - ISO Factor1:2.05; Y2 - ISO Factor6:3.44; Da - Cup Frontface Backing Diameter:17.40 in;
Komatsu BAR 56B-54-14550 BAR	Nref:1,300 rpm; Characteristic cage frequency, FTF:0.44 Hz; Mass:47.28 kg; b:18.3 mm; ra max:3 mm; Y2:4.4; B:104 mm; k:8 mm; Static load, C0:2,910 kN; d:260 mm;
Komatsu BAR 562-83-3A750 BAR	Seal:VR320; J:350.00 mm; J2:378 mm; Locating Rings (width x OD):SR215X19.5; Shaft Diameter db:115 mm; N1:24.00 mm; L:410.00 mm; G:M16; H1:140.0 mm; Seal Type:V-ring;
Komatsu BAR 196-70-17330 BAR	Shape:Flange Type; Holder Surface Treatment:Black Oxide Coating; Flange O.D. H(φ):77; Bearing I.D. d(mm):25; Days to Ship:8 Days; Bearing Used:Deep Groove Ball Bea; Seals:DD (Contact Rubber S; Type:Bearings with Housin; Bearing Retained:Yes (with retaining;