Komatsu tool 707-98-66410 tool	Flange O.D. H(φ):114; Seals:DD (Contact Rubber S; Bearing I.D. d(mm):40; Days to Ship:8 Days or more; Width T(mm):65 ～ 120; Bearing Retained:Yes (with retaining; Bearing Used:Deep Groove Ball Bea; Number of Bearings:Double; Bearing Material:[Steel] Steel;
Komatsu tool 195-15-05710 tool	Seal:Nitrile; Surface Treatment:No; Unit Body Material:Cast Iron; d:75; Bearing Unit, Type:Round flange shape; Basic Load Rating, Dynamic Rating(N):84000; Unit, Type:Insert Bearing Unit; Stroke:No; Bearing Inner Dia. Shape:Tapered hole adapter;
Komatsu tool 195-63-05110 tool	Flange O.D. H(φ):114; Seals:DD (Contact Rubber S; Bearing I.D. d(mm):40; Days to Ship:8 Days or more; Width T(mm):65 ～ 120; Bearing Retained:Yes (with retaining; Bearing Used:Deep Groove Ball Bea; Number of Bearings:Double; Bearing Material:[Steel] Steel;
Komatsu tool XA2268 tool	Seal:Nitrile; Surface Treatment:No; Unit Body Material:Cast Iron; d:75; Bearing Unit, Type:Round flange shape; Basic Load Rating, Dynamic Rating(N):84000; Unit, Type:Insert Bearing Unit; Stroke:No; Bearing Inner Dia. Shape:Tapered hole adapter;
Komatsu tool 792-610-1702 tool	Number of lubrication holes:3; Da max:78 mm; Characteristic outer ring frequency, BPF0:7.15 Hz; k:2.5 mm; Brand:SNR; ra max:1 mm; Characteristic inner ring frequency, BPFI:9.85 Hz; D:85 mm; rs min:1.1 mm; Nref:7,400 rpm;
Komatsu tool 790-452-1200 tool	Combination symbol:No; Spacer, Sleeve symbol:No; Raceway Ring Shape:Tapered Roller; Material Symbol:No; Special Configurations Code:No; I.D.(Ø):240; Symbol of Bearing Ring Shape:No; Days to Ship:8 Days; Inner/Outer Ring Material:Steel; Load Direction:Radial;
Komatsu tool 707-98-15650 tool	K - Factor7:1.83; e - ISO Factor8:0.32; D:289.974 mm; R - Cone Backface To Clear Radius1:7.110 mm; C - Cup Width:48.001 mm; Ab - Cage-Cone Frontface Clearance:3.3 mm; B:63.503 mm; r - Cup Backface To Clear Radius2:3.05 mm; Ca90 - Dynamic Thrust Rating (90 million revolutions)6:26600 lbf; G2 - Heat Generation Factor (Rib-Roller End):95.5;
Komatsu tool 799-201-1120 tool	SW:3.18 mm; T max.:100 °C; T min.:-40 °C; H2:41 mm; B:30 mm; H:98 mm; Recommended tightening torque for set screw:3.7 Nm; d:31.75 mm; Designation of housing:SP206-207/62-; L:274 mm;