| Komatsu Support and stop the use of a lump " | Bearing Retained:Yes (with retaining; Bearing Part Number:6200; Holder Surface Treatment:Electroless Nickel P; Type:Bearings with Housin; Bearing I.D. d(mm):10; Width T(mm):40; Flange Shape:Round Type; Volume Discount:Available; Number of Bearings:Double; Flange O.D. H(φ):54; |
| Komatsu Support and stop the use of a lump "207-62-51891 Support and stop the use of a lump | G:M6x1; d1:62 mm; Recommended tightening torque for set screw:8 Nm; B1:56.3 mm; C0:20.8 kN; T min.:-20 °C; Designation of housing:C209-; Designation of bearing:EX209-27G2; s1:39.7 mm; A:31 mm; |
| Komatsu Support and stop the use of a lump " | rs min:0.6 mm; B:12 mm; ra max:0.6 mm; Characteristic rolling element frequency, BSF:5.49 Hz; Mass:0.08 kg; Static load, C0:5.85 kN; D:47 mm; Nlim (grease):15,000 rpm; Da max:43 mm; Fatigue limit load, Cu:0.27 kN; |
| Komatsu Support and stop the use of a lump "14X-916-2110 Support and stop the use of a lump | Bearing Type:Thrust Tapered Rolle; D1 - Small Diameter O.D.:37.938 in; E - Shoulder Diameter - Housing:30.00 in; Dynamic Load Rating:480000 lbf; r - Fillet Radius Housing (Max):0.19 in; d - Bore Diameter:28.0000 in; Static Load Rating:8390000 lbf; D - Bearing O.D.:38.0000 in; Weight:781.00 lb; H - Shoulder Diameter - Shaft:36.12 in; |
| Komatsu Support and stop the use of a lump " | Designation of bearing:UC212-36G2T04; S:25.4 mm; Weight:1.81 kg; T max.:100 °C; T min.:-40 °C; Designation of open end cover:SCOU212-36; P:300 mm; B:65.1 mm; d:57.15 mm; Z:60.8 mm; |
| Komatsu Support and stop the use of a lump "795-903-1130 Support and stop the use of a lump | RoHS:6; Seals:ZZ (Double Shield); Bearing Retained:Yes (with retaining; Shape:Bottom Mount; Bearing Used:Deep Groove Ball Bea; Holder Surface Treatment:Not Provided; Housing Material:304 Stainless Steel; Type:Bearings with Housin; Width T(mm):12; |
| Komatsu Support and stop the use of a lump "421-S95-2922 Support and stop the use of a lump | A1:10 mm; S:17 mm; B1:43.5 mm; A2:45.5 mm; Recommended tightening torque for set screw:3.7 Nm; T max.:100 °C; d1:32.4 mm; J:63.5 mm; T min.:-20 °C; B:34 mm; |
| Komatsu Support and stop the use of a lump " | A1:10 mm; S:17 mm; B1:43.5 mm; A2:45.5 mm; Recommended tightening torque for set screw:3.7 Nm; T max.:100 °C; d1:32.4 mm; J:63.5 mm; T min.:-20 °C; B:34 mm; |