Komatsu Support and stop the use of a lump "21P-62-11581 Support and stop the use of a lump	Y - ISO Factor9:1.44; d:38.000 mm; C0 - Static Radial Rating:55000 N; B - Cone Width:17.000 mm; da - Cone Frontface Backing Diameter:42.42 mm; r - Cup Backface To Clear Radius2:1.27 mm; e - ISO Factor8:0.42; Series:L69300; Ab - Cage-Cone Frontface Clearance:1.8 mm; Cg - Geometry Factor:0.0692;
Komatsu Support and stop the use of a lump "20Y-62-16221 Support and stop the use of a lump	Flange Shape:Square Type; Holder Surface Treatment:Electroless Nickel P; Shape:Flanged Pilot Type; Number of Bearings:Double; Bearing Used:Deep Groove Ball Bea; Type:Bearings with Housin; Width T(mm):45; Bearing Material:[Steel] Steel;
Komatsu Support and stop the use of a lump "23S-46-36270 Support and stop the use of a lump	H1:19 mm; N1:21 mm; C0:15.6 kN; H2:94 mm; s1:21.45 mm; Weight:1.97 kg; Designation of housing:SP207-; d:36.51 mm; T max.:100 °C; A:48 mm;
Komatsu Support and stop the use of a lump "	d1:86 mm; C:57.2 kN; T min.:-20 °C; Weight:6.2 kg; A2:81.6 mm; J:149 mm; e:30 mm; s1:57.6 mm; L:187 mm; Designation of open end cover:SCOE213-65;
Komatsu Support and stop the use of a lump "	rs min:0.6 mm; B:12 mm; ra max:0.6 mm; Characteristic rolling element frequency, BSF:5.49 Hz; Mass:0.08 kg; Static load, C0:5.85 kN; D:47 mm; Nlim (grease):15,000 rpm; Da max:43 mm; Fatigue limit load, Cu:0.27 kN;
Komatsu Support and stop the use of a lump "	Designation of bearing:UC212-36G2T04; S:25.4 mm; Weight:1.81 kg; T max.:100 °C; T min.:-40 °C; Designation of open end cover:SCOU212-36; P:300 mm; B:65.1 mm; d:57.15 mm; Z:60.8 mm;
Komatsu Support and stop the use of a lump "209-62-77890 Support and stop the use of a lump	RoHS:6; Seals:ZZ (Double Shield); Bearing Retained:Yes (with retaining; Shape:Bottom Mount; Bearing Used:Deep Groove Ball Bea; Holder Surface Treatment:Not Provided; Housing Material:304 Stainless Steel; Type:Bearings with Housin; Width T(mm):12;
Komatsu Support and stop the use of a lump "566-15-41560 Support and stop the use of a lump	A1:10 mm; S:17 mm; B1:43.5 mm; A2:45.5 mm; Recommended tightening torque for set screw:3.7 Nm; T max.:100 °C; d1:32.4 mm; J:63.5 mm; T min.:-20 °C; B:34 mm;