Komatsu Tooth pedestal "	Designation of housing:FL212-; d:61.91 mm; G:M6x1; L:140 mm; A:48 mm; H:250 mm; S:12 mm; Designation of bearing:ES212-39G2; N:23mm; e:29 mm;
Komatsu Tooth pedestal "799-601-9210 Tooth pedestal	Grease Lubrication - T Seal:1600 rpm; Dimension F:9.76 in; Pre Install Clearance Min:0.0043 in; Y2 - Geometry Factor:3.80; e - Geometry Factor:0.26; Oil Lubrication - M/N Seal:1200 rpm; Engineering Group:Mounted Bearing; Dimension G:1.25 in; Int Radial Clearance Reduction Max:0.0025 in; Shaft Size  :3-1/2 in;
Komatsu Tooth pedestal "	T max.:100 °C; A1:30 mm; C0:18.2 kN; d:38.1 mm; A:54 mm; s1:39.7 mm; H:49.2 mm; Designation of housing:PG208-; B1:56.3 mm; E:22 mm;
Komatsu Tooth pedestal "41B-Z20-1110 Tooth pedestal	Static load, C0:92 kN; B:23 mm; Characteristic cage frequency, FTF:0.42 Hz; Min operating temperature, Tmin:-40 °C; Fatigue limit load, Cu:8.65 kN; D:72 mm; Max operating temperature, Tmax:200 °C; Y2:3.29; Nlim:12,000 rpm; rs min:1.1 mm;
Komatsu Tooth pedestal "799-601-9260 Tooth pedestal	Series:6300; Cup Part Number:6325; Da - Cup Frontface Backing Diameter:5.00 in; Cg - Geometry Factor:0.0827; Y - ISO Factor3:1.85; D:5.3150 in; r - Cup Backface To Clear Radius1:0.12 in; Design Units:Imperial; Db - Cup Backface Backing Diameter:4.61 in; e - ISO Factor2:0.32;
Komatsu Tooth pedestal "790-401-1761 Tooth pedestal	G:R1/8"; Designation of housing:FLE206N-; Designation of open end cover:SCOU206-20; Z:46.3 mm; s1:19.05 mm; Recommended tightening torque for set screw:3.7 Nm; T min.:-20 °C; B:38.1 mm; C:19.5 kN; Designation of bearing:UC206-20G2L4;
Komatsu Tooth pedestal "6735-61-6130 Tooth pedestal	G:R1/8"; Designation of housing:FLE206N-; Designation of open end cover:SCOU206-20; Z:46.3 mm; s1:19.05 mm; Recommended tightening torque for set screw:3.7 Nm; T min.:-20 °C; B:38.1 mm; C:19.5 kN; Designation of bearing:UC206-20G2L4;
Komatsu Tooth pedestal "209-01-78330 Tooth pedestal	S:19 mm; Designation of bearing:UC308-24G2T20; C:40.56 kN; SW:4.76 mm; Designation of housing:C308-; H:120 mm; T min.:-20 °C; Recommended tightening torque for set screw:16.8 Nm; s1:26 mm; A3:3 mm;