Komatsu Glass 13Y-62-13254 ELBOW	C:31.85 kN; N:M12; Designation of housing:PG209N-; L:120 mm; C0:20.8 kN; d:42.86 mm; E:22 mm; B:41.2 mm; T min.:-20 °C; H1:20 mm;
Komatsu Glass 14X-30-14420 CROSS	C:31.85 kN; N:M12; Designation of housing:PG209N-; L:120 mm; C0:20.8 kN; d:42.86 mm; E:22 mm; B:41.2 mm; T min.:-20 °C; H1:20 mm;
Komatsu Glass 425-15-18150 ELBOW	Dimension V:0.1 in; Cr - Dynamic Load Rating:18659 lbf; Bearing - Housing - Seal UPC:013992091871; Bearing Type:Split Cylindrical Ex; Dimension P:0.5 in; Series Type:Light Series; Dimension H:2.2 in; Seal Type:Viton Single Lip; Bearing UPC:013992025517; Shaft Size:1-11/16 in;
Komatsu Glass 796-427-1121 Wrench	db - Cone Backface Backing Diameter:13.35 in; a - Effective Center Location4:0.36 in; Series:940000; G2 - Heat Generation Factor (Rib-Roller End):187.4; Design Units:Imperial; G1 - Heat Generation Factor (Roller-Raceway):1771.6; da - Cone Frontface Backing Diameter:13.07 in; Cg - Geometry Factor:0.166; K - Factor8:1.45; C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1:607000 lbf;
Komatsu Glass 12Y-49-31111 ELBOW	db - Cone Backface Backing Diameter:13.35 in; a - Effective Center Location4:0.36 in; Series:940000; G2 - Heat Generation Factor (Rib-Roller End):187.4; Design Units:Imperial; G1 - Heat Generation Factor (Roller-Raceway):1771.6; da - Cone Frontface Backing Diameter:13.07 in; Cg - Geometry Factor:0.166; K - Factor8:1.45; C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1:607000 lbf;
Komatsu Glass 21T-54-66930 Glass	Roller Lining:None; Roller Type:Flat Type; Thread Size on Cam Follower (M)(mm):M8; Cam Follower Type:Standard; B:11; Shaft:Provided; D:19; Category:Cam Followers; Roller Guiding Method:Retainer Type;
Komatsu Glass 790-302-1500 Wrench	ra max:2.5 mm; b:14.9 mm; Max operating temperature, Tmax:200 °C; Y0:1.98; Radial clearance class:C4; Characteristic inner ring frequency, BPFI:10.39 Hz; Brand:SNR; Number of lubrication holes:3; Static load, C0:1,890 kN; rs min:3 mm;
Komatsu Glass 263-60-35410 ELBOW	D:52 mm; S:7.5 mm; C1:4.3 mm; Recommended tightening torque for set screw:3.7 Nm; d1:37.4 mm; d:22.22 mm; T max.:200 °C; T min.:-20 °C; C:15 mm; r:0.6;