Komatsu Glass 22T-55-31720 Glass	db - Cone Backface Backing Diameter:13.35 in; a - Effective Center Location4:0.36 in; Series:940000; G2 - Heat Generation Factor (Rib-Roller End):187.4; Design Units:Imperial; G1 - Heat Generation Factor (Roller-Raceway):1771.6; da - Cone Frontface Backing Diameter:13.07 in; Cg - Geometry Factor:0.166; K - Factor8:1.45; C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1:607000 lbf;
Komatsu Glass 198-49-31130 ELBOW	Dimension V:0.1 in; Cr - Dynamic Load Rating:18659 lbf; Bearing - Housing - Seal UPC:013992091871; Bearing Type:Split Cylindrical Ex; Dimension P:0.5 in; Series Type:Light Series; Dimension H:2.2 in; Seal Type:Viton Single Lip; Bearing UPC:013992025517; Shaft Size:1-11/16 in;
Komatsu Glass 20Y5438122GLGL Glass	Designation of bearing:EX203-11G2T20; Weight:0.54 kg; H:102 mm; B1:43.5 mm; d:17.46 mm; J1:40 mm; e:15 mm; Designation of housing:FA204-; N:10mm; A1:12 mm;
Komatsu Glass MUME033-0-1350 ELBOW	A1:16 mm; H:150 mm; C:35.1 kN; Recommended tightening torque for set screw:8 Nm; B:43.5 mm; S:10.9 mm; H1:55 mm; T max.:100 °C; T min.:-40 °C; s1:21.75 mm;
Komatsu Glass 131-30-61420 CROSS	Roller Lining:None; Roller Type:Flat Type; Thread Size on Cam Follower (M)(mm):M8; Cam Follower Type:Standard; B:11; Shaft:Provided; D:19; Category:Cam Followers; Roller Guiding Method:Retainer Type;
Komatsu Glass PZF816024508 Glass	db - Cone Backface Backing Diameter:13.35 in; a - Effective Center Location4:0.36 in; Series:940000; G2 - Heat Generation Factor (Rib-Roller End):187.4; Design Units:Imperial; G1 - Heat Generation Factor (Roller-Raceway):1771.6; da - Cone Frontface Backing Diameter:13.07 in; Cg - Geometry Factor:0.166; K - Factor8:1.45; C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1:607000 lbf;
Komatsu Glass 11Y-30-43110 CROSS	D:52 mm; S:7.5 mm; C1:4.3 mm; Recommended tightening torque for set screw:3.7 Nm; d1:37.4 mm; d:22.22 mm; T max.:200 °C; T min.:-20 °C; C:15 mm; r:0.6;
Komatsu Glass 45H-407-3310KF CROSS	A1:16 mm; H:150 mm; C:35.1 kN; Recommended tightening torque for set screw:8 Nm; B:43.5 mm; S:10.9 mm; H1:55 mm; T max.:100 °C; T min.:-40 °C; s1:21.75 mm;