Komatsu Glass 208-30-68010 CROSS	A1:16 mm; H:150 mm; C:35.1 kN; Recommended tightening torque for set screw:8 Nm; B:43.5 mm; S:10.9 mm; H1:55 mm; T max.:100 °C; T min.:-40 °C; s1:21.75 mm;
Komatsu Glass 8288-75-1291 CROSS	Cr - Dynamic Load Rating:304391 lbf; Bolt Size:4 x M36; Series Type:Medium Series; Dimension V:0.2 in; Support Type:Round Flange; Dimension P:1.5 in; Maximum Speed:750 rpm; Bearing - Housing - Seal:MSE908BXHATL; Bearing UPC:013992033253; Note:This product line wa;
Komatsu Glass 6162-14-5431 ELBOW	Roller Lining:None; Roller Type:Flat Type; Thread Size on Cam Follower (M)(mm):M8; Cam Follower Type:Standard; B:11; Shaft:Provided; D:19; Category:Cam Followers; Roller Guiding Method:Retainer Type;
Komatsu Glass 114-X11-1430 Glass	A1:16 mm; H:150 mm; C:35.1 kN; Recommended tightening torque for set screw:8 Nm; B:43.5 mm; S:10.9 mm; H1:55 mm; T max.:100 °C; T min.:-40 °C; s1:21.75 mm;
Komatsu Glass 11Y-30-01132 CROSS	C:31.85 kN; N:M12; Designation of housing:PG209N-; L:120 mm; C0:20.8 kN; d:42.86 mm; E:22 mm; B:41.2 mm; T min.:-20 °C; H1:20 mm;
Komatsu Glass 791-346-1400 Wrench	db - Cone Backface Backing Diameter:13.35 in; a - Effective Center Location4:0.36 in; Series:940000; G2 - Heat Generation Factor (Rib-Roller End):187.4; Design Units:Imperial; G1 - Heat Generation Factor (Roller-Raceway):1771.6; da - Cone Frontface Backing Diameter:13.07 in; Cg - Geometry Factor:0.166; K - Factor8:1.45; C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1:607000 lbf;
Komatsu Glass 796-550-1310 Wrench	Roller Lining:None; Roller Type:Flat Type; Thread Size on Cam Follower (M)(mm):M8; Cam Follower Type:Standard; B:11; Shaft:Provided; D:19; Category:Cam Followers; Roller Guiding Method:Retainer Type;
Komatsu Glass 201-30-73312 CROSS	D:52 mm; S:7.5 mm; C1:4.3 mm; Recommended tightening torque for set screw:3.7 Nm; d1:37.4 mm; d:22.22 mm; T max.:200 °C; T min.:-20 °C; C:15 mm; r:0.6;